Passenger’s Side Headlamp Shown; Front Parking and Turn Signal Lamp- Page 264

yellow

blue     

6-34

Passenger’s Side Headlamp Shown

B. Horizontal aim adjustment screw

C. Horizontal block index plate

D. Vertical aiming level

Start with the horizontal aim. The adjustment screws can
be turned with an E8 Torx

R

 socket.

Once the horizontal aim is adjusted, then adjust the
vertical aim.

1. Turn the horizontal aiming screw until the indicator

is lined up with zero.

2. Turn the vertical aiming screw until the level bubble

is lined up with zero.

Front Parking and Turn Signal Lamp

1. Remove the headlamp assembly. Refer to the

removal procedure earlier in this section.

2. Remove the rubber bulb access cover.

3. Twist and pull the sidemarker lamp socket

counterclockwise from the headlamp assembly.

4. Holding the base of the bulb, pull the bulb from 

the socket.

5. Push the new bulb into the socket.

6. Put the socket back into the headlamp assembly and

turn it clockwise until it is secure.

7. Replace the rubber bulb access cover.

8. Replace the headlamp assembly.