Engine Heater; Driving and Operating; The engine is designed to- Page 257

2011 Buick enclave Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
Customer Information
background image

Black plate (19,1)

Buick Enclave Owner Manual - 2011

Driving and Operating

9-19

If the vehicle starts briefly but
then stops again, repeat these
steps. This clears the extra
gasoline from the engine. Do not
race the engine immediately
after starting it. Operate the
engine and transmission gently
until the oil warms up and
lubricates all moving parts.

Notice:

The engine is designed to

work with the electronics in the
vehicle. If you add electrical parts
or accessories, you could change
the way the engine operates.
Before adding electrical
equipment, check with your
dealer. If you do not, the engine
might not perform properly. Any
resulting damage would not be
covered by the vehicle warranty.

Engine Heater

The engine coolant heater can
provide easier starting and better
fuel economy during engine
warm-up in cold weather conditions
at or below 0°F (

18°C). Vehicles

with an engine coolant heater
should be plugged in at least four
hours before starting. Some models
may have an internal thermostat in
the cord which will prevent engine
coolant heater operation at
temperatures above 0°F (

18°C).

To Use the Engine Coolant
Heater

1. Turn off the engine.

2. Open the hood and unwrap the

electrical cord. The cord is
located on the driver side of the
engine compartment. It is routed
around the windshield washer
fluid reservoir.

3. Plug the cord into a normal,

grounded 110-volt AC outlet.

{

WARNING

Plugging the cord into an
ungrounded outlet could cause an
electrical shock. Also, the wrong
kind of extension cord could
overheat and cause a fire. You
could be seriously injured. Plug
the cord into a properly grounded
three-prong 110-volt AC outlet.
If the cord will not reach, use a
heavy-duty three-prong extension
cord rated for at least 15 amps.

4. Before starting the engine, be

sure to unplug and store the
cord as it was before to keep it
away from moving engine parts.
If you do not, it could be
damaged.

The length of time the heater should
remain plugged in depends on
several factors. Ask a dealer in the
area where you will be parking the
vehicle for the best advice on this.

Detailed Information for 2011 Buick enclave Owner Manual

Lists of information found in 2011 Buick enclave Owner Manual - Page 257

  • 1. Turn off the engine.
  • 2. Open the hood and unwrap the electrical cord.
  • 3. Plug the cord into a normal, grounded 110-volt AC outlet.
  • 4. Before starting the engine, be sure to unplug and store the cord as it was before to keep it away from moving engine parts.