Vehicle Care; Removing the Spare Tire; Removing the Flat Tire and- Page 319

2013 Buick enclave Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
Customer Information
background image

Black plate (57,1)

Buick Enclave Owner Manual - 2013 - crc - 11/14/12

Vehicle Care

10-57

Removing the Spare Tire

The compact spare tire is located
under the vehicle, in front of the rear
bumper. See

Compact Spare Tire

on page 10

64

for more information.

1. Rear Convenience Center

2. Wrench (Three-Piece Shown,

One-Piece Similar)

3. Carpet Cutout

4. Hoist Shaft

5. Compact Spare Tire

6. Retainer

1. Open the storage compartment

door of the convenience
center (1) that is nearest the
liftgate.

2. Open the carpet cutout (3) that

is located through the hole of the
storage compartment.

3. Attach the wrench (2) into the

hoist shaft (4).

4. Turn the wrench (2)

counterclockwise to lower the
spare tire (5) to the ground.
Continue turning the wrench until
the spare tire can be pulled out
from under the vehicle.

5. Tilt the retainer and slip it

through the wheel opening to
remove the spare tire from the
cable.

6. Turn the wrench clockwise to

raise the cable back up after
removing the spare tire.

Do not store a full-size or a flat
road tire under the vehicle. See

Storing the Spare Tire

and

Storing the Flat Tire

later in this

section.

Removing the Flat Tire and
Installing the Spare Tire

1. Do a safety check before

proceeding. See

If a Tire Goes

Flat on page 10

54

for more

information.

Detailed Information for 2013 Buick enclave Owner Manual

Lists of information found in 2013 Buick enclave Owner Manual - Page 319

  • 1. Rear Convenience Center 2.
  • 3. Carpet Cutout 4.
  • 5. Compact Spare Tire 6.
  • 1. Open the storage compartment door of the convenience center (1) that is nearest the liftgate.
  • 2. Open the carpet cutout (3) that is located through the hole of the storage compartment.
  • 3. Attach the wrench (2) into the hoist shaft (4).
  • 4. Turn the wrench (2) counterclockwise to lower the spare tire (5) to the ground.
  • 5. Tilt the retainer and slip it through the wheel opening to remove the spare tire from the cable.
  • 6. Turn the wrench clockwise to raise the cable back up after removing the spare tire.
  • 1. Do a safety check before proceeding.