Vehicle Care- Page 316

2015 Buick enclave Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
background image

Black plate (61,1)

Buick Enclave Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-

7576029) - 2015 - CRC - 8/15/14

Vehicle Care

10-61

Warning (Continued)

damage, be sure to fit the jack lift
head into the proper location
before raising the vehicle.

7. Raise the vehicle by turning the

wrench clockwise in the jack.
Raise the vehicle far enough off
the ground so that there is
enough room for the spare tire to
fit under the wheel well.

8. Remove all the wheel nuts and

the flat tire.

9. Remove the plastic spare tire

heat shield by pulling the rubber
latch. Store the plastic spare tire
heat shield. See

Storing the

Spare Tire

later in this section

for more information.

{

Warning

Rust or dirt on a wheel, or on the
parts to which it is fastened, can
make wheel nuts become loose
after time. The wheel could come
off and cause an accident. When

(Continued)

Warning (Continued)

changing a wheel, remove any
rust or dirt from places where the
wheel attaches to the vehicle. In
an emergency, a cloth or a paper
towel can be used; however, use
a scraper or wire brush later to
remove all rust or dirt.

{

Warning

Never use oil or grease on bolts
or nuts because the nuts might
come loose. The vehicle's wheel
could fall off, causing a crash.

10. Remove any rust or dirt from

the wheel bolts, mounting
surfaces, and spare wheel.

11. Place the spare tire on the

wheel mounting surface.

12. Put the nuts on by hand by

turning them clockwise until the
wheel is held against the

Detailed Information for 2015 Buick enclave Owner Manual

Lists of information found in 2015 Buick enclave Owner Manual - Page 316

  • 7. Raise the vehicle by turning the wrench clockwise in the jack.
  • 8. Remove all the wheel nuts and the flat tire.
  • 9. Remove the plastic spare tire heat shield by pulling the rubber latch.
  • 11. Place the spare tire on the wheel mounting surface.