Buick/Chevrolet/GMC InTouch Infotainment System (GMNA-Localizing-U.S/
Canada-9234745) - 2016 - crc - 9/9/15
38
Rear Seat Infotainment
For optimal audio performance, the
headphones must be worn correctly.
Wear headphones with the
headband over the top of the head
for best audio reception. The
symbol L (Left) appears on the
outside bottom edge of the ear cup
and should be positioned on the left
ear. The symbol R (Right) appears
on the outside bottom edge of the
ear cup and should be positioned on
the right ear.
Caution
Do not store the headphones in
heat or direct sunlight. This could
damage the headphones and
repairs will not be covered by the
warranty. Storage in extreme cold
can weaken the batteries. Keep
the headphones stored in a cool,
dry place.
If the foam ear pads attached to the
headphones become worn or
damaged, the pads can be replaced
separately from the headphone set.
To purchase replacement ear pads,
call 1-888-293-3332, then prompt
zero (0), or contact your dealer.
Store headphones in the front floor
console and not in the front seat
back pocket. Headphone damage
can occur when the second row
seats are folded forward.
Battery Replacement
To change the batteries on the
headphones:
1. Turn the screw to loosen the
battery door on the left side of
the headphones. Slide the
battery door open.
2. Replace the two batteries in
the compartment. Make sure
that they are installed correctly,
using the diagram on the inside
of the battery compartment.
3. Slide back the battery door and
tighten the door screw.
If the headphones are to be stored
for a long period of time, remove the
batteries and keep them in a cool,
dry place.
Audio/Video (A/V) Jacks
1. Video Input
2. Left Audio Input
3. Right Audio Input
The RCA type A/V jacks are color
coded to match typical home
entertainment system equipment.
The A/V jacks, on the rear of the
floor console, allow audio or video
signals to be connected from an
auxiliary device such as a
camcorder or a video game unit to
the RSE system. Adapter
connectors or cables (not supplied)
might be required to connect the