Audio Systems; Radio Controls; Setting the Time- Page 9

9

ENTERTAINMENT

Audio Systems

Setting the Time

Press and hold the H button on the
sound system faceplate until the correct
hour appears on the display. Press
and hold M until the correct minute
appears. The ignition does not need to
be turned on.

Radio Controls

(Power):

Press to turn the system on

or off.

(Volume):

Turn to increase/decrease

volume.

BAND:

Press to switch between AM,

FM1/FM2 and XM1/XM2 (if equipped).

DISP (Display): 

Press to switch the dis-

play between the radio station frequency
and the time. With the ignition off, press
to display the time. 
While in XM mode (if equipped), press
to display the artist, song title, category
and channel.

INFO (Information) 

(if equipped): While

in XM mode (if equipped), press to dis-
play a current radio station message
and other information, if available. 

SCV (Speed Compensated Volume):

Press to select Off, Min, Med or Max
radio volume compensation as vehicle
speed increases.

(Tune/Balance/Fade):

Turn to

select radio stations. 
To set Bass/Treble, push and release
until BAS or TRE appears. Turn to
increase or decrease. To adjust to the
middle position, press and hold until it
beeps.
To adjust Balance, push and release
until BAL appears. Turn the knob to
move the sound toward the right or left.
To adjust Fade, push until FAD appears.
Turn the knob to move the sound toward
the front or rear. 
To adjust all controls to the middle posi-
tion, push/hold the speaker knob when
no tone or speaker control is displayed.
ALL CEN appears and the unit beeps.

(Seek):

Press and release the

left/right Seek arrow to go to the previ-
ous or next station and stay there. 
To scan, press and hold either arrow for
more than two seconds. SCAN appears
on the display and a beep sounds. The
radio finds a station, plays a few sec-
onds and advances to the next. Press
either arrow or a pushbutton to stop
scanning. 
To scan preset stations, press and hold
either arrow for more than four seconds.
PSCAN appears and two beeps sound.
Press either arrow or a pushbutton to
stop scanning presets.