Auto lock function operation stop beeper- Page 163

uu

Locking and Unlocking the Doors

u

Locking/Unlocking the Doors from the Outside

162

Co
ntrols

To temporarily deactivate the function:

1.

Set the power mode to OFF.

2.

Open the driver’s door.

3.

Using the master door lock switch, operate 
the lock as follows:
Lock  

Unlock  

Lock  

Unlock.

u

The beeper sounds and the function is 
deactivated.

To restore the function:

•

Set the power mode to ON.

•

Lock the vehicle without using the auto lock 
function.

•

With the remote key on you, move out of 
the auto lock function operation range.

•

Open any door.

1

Locking the doors and trunk (Walk away auto lock

®

)

The auto lock function does not operate when any of 
the following conditions are met.

•

The remote key is inside the vehicle.

•

A door or the hood is not closed.

•

The power mode is set to any mode other than 
OFF.

•

The remote key is not located within a radius of 
about 5 feet (1.5 m) from the vehicle when you get 
out of the vehicle and close the doors.

Auto lock function operation stop beeper

After the auto lock function has been activated, the 
auto lock operation stop beeper sounds for 
approximately two seconds in the following cases.

•

The remote key is put inside the vehicle through a 
window.

•

You are located too close to the vehicle.

•

The remote key is put inside the trunk.

If the warning beeper sounds, check that you are 
carrying the remote key. Then, open/close a door and 
confirm the auto lock activation beeper sounds once.