Perform - Page 266

266

5-5. Using the other interior features

this sequence (press/hold/release) 
up to 3 times to complete pro-
gramming.
If the garage door opener motor 
operates when the HomeLink

®

button is pressed, the garage door 
opener motor recognizes the 
HomeLink

®

 signal.

■

Enabling 2-way communication 
with a garage door (only available 
for compatible devices)

When enabled, 2-way communication 
allows you to check the status of the 
opening and closing of a garage door 
through indicators in your vehicle.
2-way communication is only available 
if the garage door opener motor used 
is a compatible device. (To check 
device compatibility, refer to 
www.homelink.com.)

1

Within 5 seconds after program-
ming the garage door opener has 
been completed, if the garage door 
opener motor is trained to Home-
Link

®

, both garage door operation 

indicators will flash rapidly (green) 
and the light on the garage door 
opener motor will blink twice, indi-
cating that 2-way communication is 
enabled.

If the indicators do not flash, perform 

2

 and 

3

 within the first 10 presses of the Home-

Link

®

 button after programming has been 

completed.

2

Press a programmed HomeLink

®

button to operate a garage door.

3

Within 1 minute of pressing the 
HomeLink

®

 button, after the 

garage door operation has 
stopped, press the “Learn” or 
“Smart” button on the garage door 
opener motor. Within 5 seconds of 
the establishment of 2-way com-
munication with the garage door 
opener, both garage door opera-
tion indicators in the vehicle will 
flash rapidly (green) and the light 
on the garage door opener motor 
will blink twice, indicating that 
2-way communication is enabled.

■

Reprogramming a single Home-
Link

®

 button

When the following procedure is per-
formed, buttons which already have 
devices registered to them can be 
overwritten:

1

With one hand, press and hold the 
desired HomeLink

®

 button.

2

When the HomeLink

®

 indicator 

starts flashing (orange), continue to 
hold the HomeLink

®

 button and 

perform “Programming Home-
Link

®

” 

1

 (it takes 20 seconds for 

the HomeLink

®

 indicator to start 

flashing).

■

Before programming

●

Install a new battery in the transmitter.