10. Troubleshooting - Page 26

26 

10. Troubleshooting 

z

  Even if you think the device has broken down or malfunctioned, check 

once more to be sure. 

z

  If an error occurs, read through this instruction manual thoroughly, and 

check the following items in the table below. If the error or problem persists, 

do not try to repair the device by yourself. Consult with the authorized 

Mazda dealer where you purchased the vehicle or device. 

Problem Check 

Item 

Troubleshoot 

Are the batteries inserted 
correctly? 

Check the status of the batteries. 
(Refer to p.13.) 

Have the batteries run 
out? 

Replace the batteries with new ones. 
(Refer to p.13.) 

Did you press more than 
one switch at the same 
time? (except the warm-up 
time setting operation) 

Refer to the basic operation items to perform 
the remote control operation correctly. 
(Refer to p.14.) 

Remote control 
does not work 

Did you try to conduct an 
operation too quickly right 
after another operation 
was sent? 

The next transmission cannot be sent while 
the LCD display appears. Wait until the 
display turns off before conducting an 
operation. 
(Refer to p.12.) 

Did you make a mistake 
with the "Engine start" 
operation on the remote 
control? 

Refer to the "Engine start operation" section 
on p.15. 

When the function or start 
switch was pressed, was 
another switch pressed at 
the same time or ahead of 
those switches? 

Do not press another switch at the same time 
or ahead of those switches. 

Have the engine start 
conditions been satisfied? 

Check the engine start conditions.    (Refer to 
p.14, p.16.) 

Engine does 
not start using 
remote control 

Does the Error display 
appear on the LCD 
monitor of the remote 
control? 

Refer to the "Condition Error Display" section 
on p.16. 

Engine stops 
after starting it 
with the remote 
control 

Are the engine stop 
conditions shown in p.19 
true? 

The engine will stop if one of the conditions 
shown in p.19 is true.