9-1. Engine start operation ; ADVICE - Page 15

15 

9-1. Engine start operation 

z

  Press the function switch once. 

The LCD display will appear as 
shown on the right. 
 
 
 

z

  Press the start switch while the 

above LCD display is shown until 
it beeps. 

After the send mark flashes, the send 
operation is completed. After the send 
operation is completed, the controller 
will send an answer back signal.   

*Press the start switch within 2 seconds 
after the LCD display appears. If the 
start switch is not pressed in time and 
the LCD display disappears, start the 
procedure over again from step 1. 

 
When the remote control receives a 
response from the vehicle, it indicates 
the engine start operation with a 
display (on the right) and a melody. 
 
 
 

The LCD display will appear when the 
switch is released. 

ADVICE 

Within 2 sec.

Function switch 

Start switch 

Engine start 

standby 

Engine start 
initiated 

After 8 – 15 sec. 

・ 

After the engine start operation is initiated, the controller will automatically send 

an answer back signal 2 – 3 times. 

・ 

If there is a transmission error, there will not be an answer back signal after the 

second time. 

・ 

If the engine start conditions are not satisfied, 

the engine start operation cannot be performed. 

・ 

For vehicles equipped with an automatic wiper function, when the engine start 

operation is activated with the remote control, the wipers will not turn on even 

when the wiper switch is set to the “AUTO” position and it begins to rain. 

ADVICE 

⇒

p.14