Always check the Owner’s Manual for more operating information and safety features ; 1. Fore-aft adjustment; 2. Raise/lower seat- Page 9

S E A T S

Always check the Owner’s Manual for more operating information and safety features 

Manual seat

1. Fore-aft adjustment

Lift lever and hold, slide seat,
release lever.

2. Raise/lower seat

(Driver’s seat only)

Pull/push lever and release.

3. Seat back angle

To adjust: Lift and hold lever, 
lean forward or backward 
to tilt seat, release lever.

4. Manual lumbar adjustment

(Driver’s seat only) 

Pull lever forward repeatedly 
for more support.

5. Head restraint

To raise/lower: Pull up/hold release
button (

11

) and push down.

Power seat*

6. Seatback angle

Press front/rear of switch.

7. Power lumbar adjustment*

Press front/rear of switch to
increase/decrease lumbar support.

Seats

Seats

WARNINGS: Do not adjust
seats while driving.
Seat belts must always be
worn when vehicle is in motion.
Air bags are supplemental 
and do not replace seat 
belt usage.
Always wear your seat belt
and properly secure children 

1

2 and under in the rear seat.

Even with a deactivation 
system, never place rear-facing 
infant-safety seat in front 
of any air bag, an infant is 
in serious danger of being 
injured or killed.
If you must install a forward-
facing child-safety seat in 
the front seating position,
move vehicle seat as far 
back as possible.

Seat belt emergency
locking mode

Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more.

Automatic locking mode 
(all seat belts except 
driver’s seat belt)

Must be used when installing
child-safety seat.
To activate: Pull webbing fully 
out of retractor, allow belt to
retract until click is heard; 
belt will only tighten.
To disengage: Unbuckle belt and
allow webbing to retract fully.

Shoulder belt
height 
adjustment

To raise: Push
adjuster up.
To lower: 
Pull button (

1

),

slide down; release button.

WARNING: Make sure adjuster
locks in one of its positions.

Child-safety seat

To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner’s Manual 
for proper installation and child
seat tether and LATCH system 
instructions.

WARNING: Use age 
appropriate child restraints,
see Owner’s Manual and 
state or province laws.

5

11

6

10 8

9

7

5

11

1

2

3

4

1

*Denotes optional equipment

8. Raise/lower front of seat

Pull/push front of switch vertically.

Fore/aft adjustment

Slide switch horizontally. 

Raise/lower rear of seat

Pull/push rear of switch vertically.

Raise/lower seat 

Pull/push center of switch vertically.

Seat position memory*

Adjust seat, then press and hold
set button (

9

), then select and

press a memory position button
(

1

0

) to save setting.

Tip: To program memory seat
into advanced key*/retractable
key, with ignition off; key
removed and driver’s door open,
press and hold set button (9)
while holding unlock button on
transmitter until beep is heard.