When Driving; Vehicle lane line display- Page 254

4–124

When Driving

i-ACTIVSENSE

Drive the vehicle in the center of the vehicle lane while the system is on standby. The 

system becomes operational when all of the following conditions are met.



 The system detects white (yellow) lane lines on both the right and left sides, or on either 

side.



 The vehicle speed is about 60 km/h (37 mph) or faster.



 The vehicle is driven on a straight road or road with gentle curves.



 The engine is running.

The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) goes on 

stand-by status in the following cases:



 The system cannot detect white (yellow) lane lines.



 The vehicle speed is less than about 60 km/h (37 mph).



 The vehicle is making a sharp curve.



 The vehicle is making a curve at an inappropriate speed.

NOTE



  The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) remains 

on stand-by until it detects white (yellow) lines on both the left and right sides, or on 

either side.



  When the system detects a white (yellow) lane line on one side only, the system will not 

activate warnings for the lane line on the side that is not being detected.



  The distance and warning sensitivity (likelihood of a warning) which the system uses to 

determine the possibility of a lane departure can be changed.

  Refer to Setting Change (Personalization Features) on page 9-12.

Vehicle lane line display

When the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) 

detects white (yellow) lines on both the left and right sides and becomes operational, the 

vehicle lane lines are indicated in the active driving display.

Auto cancel

Under the following conditions, the Lane-keep Assist System (LAS) & Lane Departure 

Warning System (LDWS) is automatically canceled. The Lane-keep Assist System (LAS) 

& Lane Departure Warning System (LDWS) is automatically re-enabled when it becomes 

operational.



 The temperature inside the camera is high or low.



 The windshield around the camera is foggy.



 The windshield around the camera is blocked by an obstruction, causing poor forward 

visibility.

Mazda3_8FL6-EA-16F_Edition2.indb   124

2016/08/10   17:36:54