Voice Recognition Learning Function (Speaker Enrollment); Voice Recognition; Learning Function- Page 284

Voice Recognition

Learning Function

(Speaker Enrollment)

The voice recognition learning function
enables voice recognition appropriate to
the characteristics of the user's voice. If
the recognition of the voice input
commands to the system is not adequate,
this function can largely improve the
system's voice recognition of the user. If
your voice can be recognized sufficiently
without using this function, you may not
realize the added benefit of the function.
To register your voice, the voice input
command list must be read out. Read out
the list when the vehicle is parked.
Perform the registration in as quiet a place
as possible (page 5-60). The registration
must be performed completely. The
required time is a few minutes. The user
needs to be seated in the driver's seat with
the voice input command list for voice
recognition learning visible.

▼

When voice recognition learning is
done for the first time

1. Press the pick-up button or talk button

with a short press.

2.

Say:

 [Beep] “Voice training”

3.

Prompt:

 “This operation must be

performed in a quiet environment
while the vehicle is stopped. See the
owner's manual for the list of required
training phrases. Press and release the
talk button when you are ready to
begin. Press the hang-up button to
cancel at any time.”

4. Press the talk button with a short press.

5. The voice guidance reads out the voice

input command number (refer to the
voice input command list for voice
recognition learning). (Ex. “Please
read phrase 1”)

6.

Say:

 [Beep] “0123456789” (Say the

voice input command for voice
recognition learning (1 to 8) according
to the voice guidance.)

7.

Prompt:

 “Speaker enrollment is

complete.”

NOTE

If an error occurred in the voice
recognition learning, re-learning can be
done by pressing the talk button with a
short press.

▼

Voice recognition re-learning

If voice recognition learning has already
been done.
1. Press the pick-up button or talk button

with a short press.

2.

Say:

 [Beep] “Voice training”

3.

Prompt:

 “Enrollment is enabled/

disabled. Would you like to disable/
enable or retrain?”

4.

Say:

 [Beep] “Retrain”

5.

Prompt:

 “This operation must be

performed in a quiet environment
while the vehicle is stopped. See the
owner's manual for the list of required
training phrases. Press and release the
talk button when you are ready to
begin. Press the hang-up button to
cancel at any time.”

6. Press the talk button with a short press.
7. The voice guidance reads out the voice

input command number (refer to the
voice input command list for voice
recognition learning). (Ex. “Please
read phrase 1”)

Interior Features

Audio Set [Type A (non-touchscreen)]

5-62

MX-5_8GF7-EA-17J_Edition2

2017-10-31 14:07:27