Driver Controls; WARNING: Make sure that the liftgate door and/or window are; closed to prevent exhaust fumes from being drawn into the- Page 56

2005 Mazda Tribute Owners Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

background image

WARNING: Make sure that the liftgate door and/or window are
closed to prevent exhaust fumes from being drawn into the
vehicle. Exhaust fumes contain carbon monoxide which can
injure your lungs and cause drowsiness and even death. This
will also prevent passengers and cargo from falling out. If you
must drive with the liftgate door or window open, keep the
vents open so outside air comes into the vehicle.

LUGGAGE RACK

The maximum load for the roof rack is 100 lbs (45 kg), evenly
distributed on the cross-bars. If it is not possible to evenly distribute the
load, position it in the center or as far forward on the cross-bars (if
equipped) as possible. Always use the adjustable tie down loops to
secure the load.

To adjust the cross-bar (if equipped) position:

1. Loosen the thumbwheel at both ends of the cross-bar (both

cross-bars are adjustable).

2. Slide the cross-bar to the desired location.

3. Tighten the thumbwheel at both ends of the cross-bar.

To remove the cross-bar assembly (if equipped) from the roof
rack side rails:

1. Loosen the thumbwheel at both

ends of the cross-bar (both
cross-bars are adjustable).

2. Slide the cross-bar to the end of

the rail.

3. Use a long, flat object to

depress the tongue in the
endcaps on both sides of the
cross-bar.

4. Slide the cross-bar assembly off the end of the rail.

To reinstall the cross-bar assembly (if equipped) to the roof rack
side rails:

1. Slide the cross-bar assemblies over the end cap tongue and into the

side rails.

2. Tighten thumbwheel at both ends of the cross-bar.

Driver Controls

56

Detailed Information for 2005 Mazda Tribute Owners Manual

Lists of information found in 2005 Mazda Tribute Owners Manual - Page 56

  • 1. Loosen the thumbwheel at both ends of the cross-bar (both cross-bars are adjustable).
  • 2. Slide the cross-bar to the desired location.
  • 3. Tighten the thumbwheel at both ends of the cross-bar.
  • 1. Loosen the thumbwheel at both ends of the cross-bar (both cross-bars are adjustable).
  • 2. Slide the cross-bar to the end of the rail.
  • 3. Use a long, flat object to depress the tongue in the endcaps on both sides of the cross-bar.
  • 4. Slide the cross-bar assembly off the end of the rail.
  • 1. Slide the cross-bar assemblies over the end cap tongue and into the side rails.
  • 2. Tighten thumbwheel at both ends of the cross-bar.