Headlamp High/Low-Beam Changer; Flash-to-Pass Feature; Windshield Wipers- Page 103

2-39

If the arrow flashes faster than normal as you signal a
turn or a lane change, a signal bulb may be burned out
and other drivers won’t see your turn signal.

If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check for burned

-

out bulbs and then check

the fuse (see “Fuses and Circuit Breakers” in the Index).

A chime will sound if you leave your turn signal on for
more than 3/4 mile (1.2 km).

Headlamp High/Low-Beam Changer

To change your headlamps from low beams to high
beams, or high to low, pull the multifunction lever all
the way toward you. Then release it.

When the high beams are on
this light, located on the
instrument panel cluster,
will also be on.

Flash-to-Pass Feature

This feature lets you use your high

-

beam headlamps 

to signal the driver in front of you that you want to pass.
It works even if your headlamps are off.

To use it, pull the turn signal lever toward you a little,
but not so far that you hear a click.

If your headlamps are off or on low beam, your
high

-

beam headlamps will turn on. They’ll stay on as

long as you hold the lever toward you and the
high

-

beam indicator on the dash will come on. Release

the lever to return to normal operation.

Windshield Wipers

To operate the windshield wipers turn the band located
on the multifunction lever upward or downward.

WIPER: Turn this band to control the 
windshield wipers.

OFF: Turn the band to OFF to turn off the 
windshield wipers.

LO (Low Speed): Turn the band away from you to 
LO and past the delay settings for steady wiping at 
low speed.