Remote Vehicle Start ; Rear Vision Camera (if equipped); See Section 2 of your Owner Manual.- Page 21

• At 8 ft. (2.5 m), one light illuminates.
• At 40 in. (1.0 m), two lights illuminate.
• At 23 in. (0.6 m), all three lights

illuminate.

• At 12 in. (0.3 m), a chime sounds and

all three lights flash.

Use the Driver Information Center to
turn off the system when towing. The
system automatically turns back on after
each vehicle start.

Rear Vision Camera (if equipped)

When the vehicle is shifted into
Reverse, a view of the area behind the
vehicle is displayed on the inside rear-
view mirror or the navigation system
screen (if equipped).
The camera is located above the rear
license plate. Clean the camera lens
with water and a soft cloth.

See Section 2 of your Owner Manual.

21

Remote Vehicle Start 
(if equipped)

This feature allows you to start the
engine from outside the vehicle by
using the Remote Keyless Entry (RKE)
transmitter. The remote start capability
must be turned on using the Driver
Information Center.
Based on outside temperature, the
vehicle’s automatic climate control
system will default to a heating or
cooling mode and the heated seats
(if equipped) will turn on.

Starting the Vehicle

To remote-start the vehicle:
1. Aim the RKE transmitter at the

vehicle. (Transmitter range is within
approximately 195 feet of the
vehicle.)

2. Press and release the 

(Lock)

button on the transmitter.

3. Immediately press and hold the 

(Remote Start) button for about four
seconds. When the vehicle starts,
the parking lamps will light and
remain on while the engine is
running. The engine will continue
running for 10 minutes.

4. Repeat these steps for a 10-minute

time extension. Only two consecutive
remote starts are allowed.

When you enter the vehicle after a
remote start, the ignition must be turned
to the On position before driving.

Canceling a Remote Start

If you wish to turn off the engine instead
of driving after a remote start, perform
one of the following functions:
• Press and hold the 

(Remote Start)

button until the parking lamps turn off.

• Press and release the Hazard

Warning Flashers button. Press it
again to turn off the flashers.

• Turn the key in the ignition switch to

the On position and then off.

See Section 2 of your Owner Manual. 

Note:

The Remote Vehicle Start feature

will not operate if the key is in the igni-
tion, the hood or liftgate is open, or the
Check Engine light is illuminated on the
instrument panel cluster.