Cruise Control; Set Cruise Control; Resume Set Speed- Page 11

11

Rainsense™ Wipers (if equipped)

The Rainsense system monitors the

amount of moisture on the windshield

and automatically operates the wipers

as needed, depending on driving condi-

tions and the sensitivity setting. The

moisture sensor is mounted on the inte-

rior side of the windshield behind the

rearview mirror.

The Rainsense wipers operate in a

delay mode as well as a continuous low

or high speed as needed. If the system

is left on for long periods of time, occa-

sional wipes may occur without any

moisture on the windshield to indicate

the system is active.

To activate the Rainsense wipers: 

Turn the wiper band to one of the five

sensitivity levels within the delay area.

The position closest to OFF is the low-

est sensitivity level. Each higher sensi-

tivity level increases the frequency of

wipes. The system can be overridden at

any time by manually turning the wiper

band to LO or HI speed.

See Section 3 of your Owner Manual.

Cruise Control

Set Cruise Control

The Cruise Control buttons are located

on the steering wheel. Press the

ON/OFF button to turn Cruise Control

on. Accelerate to the speed you want 

to set.

Press the SET/COAST button. The

Cruise Control light on the instrument

cluster will illuminate. Remove your foot

from the accelerator pedal.

Resume Set Speed

Applying the brakes will turn the Cruise

Control off.

Press the RESUME/ACCEL button.  

The vehicle’s preset speed will resume.

OFF

Press ON/OFF or step on the brake

pedal.

See Section 3 of your Owner Manual.

Notice:

Turn the Rainsense 

wipers off to avoid wiper damage

when going through an automatic

car wash.

Headlamps — High Beam

High/Low Beam Changer

Pull the turn signal lever toward you until

it clicks to change from low beam to

high beam.

Flash-To-Pass

Pull and hold the turn signal lever toward

you briefly to flash the headlamps.

See Section 3 of your Owner Manual.