Heated Washer Fluid ; See Section 3 of your Owner Manual.; Rainsense™ II Windshield- Page 16

Getting to Know Your Lucerne

16

The rear parking assist display is located

on the rear shelf. The lights on the dis-

play provide distance information. Low-

toned beeps sound from the rear speak-

ers (for objects near the rear bumper).

See Section 3 of your Owner Manual.

Rainsense™ II Windshield

Wipers (if equipped)

The Rainsense™ II windshield wipers

use a moisture sensor to automatically

operate the wipers when needed, depend-

ing on driving conditions and the sensi-

tivity setting. If the system is left on for

long periods, an occasional wipe may

occur without any moisture on the wind-

shield to indicate the system is activated.

The headlamps and parking lamps also

will be turned on automatically when the

Rainsense wipers are active if the exteri-

or lamp control switch is in the AUTO

position.

The windshield wipers control is located

on the multifunction stalk on the left side

of the steering column. It includes the

following settings:

(Mist): Rotate the control band down

to this position to turn the wipers on for

one wipe.

(Off): Rotate the control band to this

position to turn the wipers Off.

(Sensitivity Setting): Rotate the

control band up to one of the sensitivity

levels to activate the Rainsense func-

tion. The position closest to Off is the

lowest sensitivity level.

(Low): Rotate the control band up

to this position to operate the wipers on

the Low setting.

(High): Rotate the control band up

to this position to operate the wipers on

the High setting.

(Washer Fluid): Push the paddle on

top of the multifunction lever to spray

washer fluid on the windshield.

See Section 3 of your Owner Manual.

Heated Washer Fluid 

(if equipped)

Slide and release the  (Heated

Washer Fluid) switch on the multifunc-

tion lever to start four automatic heated

wash/wipe cycles. The first cycle may

take up to 45 seconds to occur before

the washer fluid is heated. The remain-

ing cycles may take up to 20 seconds to

occur. The system determines the

amount of fluid and activates the wipers.

Slide and release the switch again to

cancel any remaining cycles. 

See Section 3 of your Owner Manual.

Lucerne06Beta6.qxd  9/8/05  9:04 PM  Page 16