Transmitter Battery; Keys, Doors, and Windows; Starting the Vehicle with a Low- Page 32

2017 Buick Regal Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
background image

Buick Regal Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-

9804381) - 2017 - crc - 8/30/16

Keys, Doors, and Windows

31

transmitters. This feature is not
available in Canada. This procedure
will take approximately 30 minutes
to complete. The vehicle must be off
and all of the transmitters you wish
to program must be with you.

1. Insert the vehicle key of the

transmitter into the key lock
cylinder located on the outside
of the driver door and turn the
key to the unlock position,
counterclockwise, five times
within 10 seconds.

The Driver Information Center
(DIC) displays REMOTE
LEARN PENDING,
PLEASE WAIT.

2. Wait for 10 minutes until the

DIC displays PRESS ENGINE
START BUTTON TO LEARN
and then press the ENGINE
START/STOP button.

The DIC display will again
show REMOTE LEARN
PENDING, PLEASE WAIT.

3. Repeat Step 2 two additional

times. After the third time all
previously known transmitters

will no longer work with the
vehicle. Remaining transmitters
can be relearned during the
next steps.

The DIC display should now
show READY FOR REMOTE
# 1.

4. Place the new transmitter into

the transmitter pocket with the
buttons facing up. The
transmitter pocket is located
inside the center console
cupholder. The cupholder liner
will need to be pulled out to
access the transmitter pocket.

5. Press the ENGINE START/

STOP button. When the
transmitter is learned, the DIC
will show that it is ready to
program the next transmitter.

6. Remove the transmitter from

the transmitter pocket and
press

K

.

To program additional
transmitters, repeat Steps 4

6.

When all additional transmitters
are programmed, press and
hold the ENGINE START/
STOP button for 12 seconds to
exit programming mode.

Starting the Vehicle with a Low
Transmitter Battery

If the transmitter battery is weak or if
there is interference with the signal ,
the DIC may display NO REMOTE
DETECTED or NO REMOTE KEY
WAS DETECTED PLACE KEY IN
TRANSMITTER POCKET THEN
START YOUR VEHICLE when you
try to start the vehicle. The
REPLACE BATTERY IN REMOTE
KEY message may also be
displayed at this time.

Detailed Information for 2017 Buick Regal Owner Manual

Lists of information found in 2017 Buick Regal Owner Manual - Page 32

  • 1. Insert the vehicle key of the transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position, counterclockwise, five times within 10 seconds.
  • 2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the ENGINE START/STOP button.
  • 3. Repeat Step 2 two additional times.
  • 1. 4.
  • 5. Press the ENGINE START/ STOP button.
  • 6. Remove the transmitter from the transmitter pocket and press K .
  • 6. When all additional transmitters are programmed, press and hold the ENGINE START/ STOP button for 12 seconds to exit programming mode.