RAISE/LOWER CUTOUT- Page 12

Know the Hazards

RAISE/LOWER CUTOUT

Your truck may be equipped with automatic cutout of raise
and lower at selected heights.

If Raise or Lower stops and the red fork symbol on the
display is lit, you are at a raise or lower cutout height.

To travel past the cutout height, push the Cutout Override
button and, at the same time, move the Raise/Lower handle.

Be very careful and watch that you don't raise, lower or
drive into overhead obstructions when using the Cutout
Override.

Raise & Lower  22

RAISE/LOWER CUTOUT OVERRIDE

Using the Cutout Override allows you to travel, or raise
the platform, into areas where there are obstructions and
hazards such as pipes, ducts, conduits, low ceilings etc.
Hitting any obstruction could tip the truck over, causing
serious injury or even death.

Watch out for obstructions anytime you're operating your
truck.  Be even more careful when using Cutout Override.

Raise & Lower

21   Raise & Lower

RAISE & LOWER

Primary raise and lower lets you move
the entire operator platform, and forks, up or
down on the primary mast.

Auxiliary raise and lower lets you move just
the forks up or down on the auxiliary mast.

PRIMARY RAISE/LOWER

Move the Raise/Lower handle toward
you to raise the platform and forks.
Move the handle away from you to
lower the platform and the forks.

The farther you move the handle the
faster the platform will raise or lower.

AUXILIARY RAISE/LOWER

Press the button in the end of the handle
and move the handle toward you to
raise only the forks.  Press the button
and move the handle away from you
to lower only the forks.

The farther you move the handle the
faster the forks will raise or lower.

Note:

Emergency manual lowering valve

located behind power unit door.