Note ; 9-2. Engine stop operation - Page 18

18 

9-2. Engine stop operation 

This operation only applies when the engine has been started with the 

remote control. 

z

  Press the stop switch until it 

beeps. 

The LCD display will appear as 

shown on the right. After the send 

mark flashes, the send operation is 

completed. After the send operation 

is completed, the controller will send 

an answer back signal. 

When the remote control receives a 

response from the vehicle, it 

indicates the engine stop operation 

with a display (on the right) and a 

melody. 

・ 

On some vehicle models, the engine also stops when the shift lever is pressed. 

・ 

The controller buzzer will sound if the engine is stopped for reasons other than a 

normal engine stop or the pre-set engine warm-up time has elapsed. 

Note 

Stop switch 

Engine stop

Send error 

Receive 
error