Owner Maintenance; Maintenance and Care- Page 399

3. Tilt the blade assembly and remove it

from the arm.

CAUTION

To prevent damage to the windshield
let the wiper arm down easily, do not
let it slap down on the windshield.

4. Pull down the blade rubber and slide it

out of blade holder.

5. Remove the metal stiffeners from each

blade rubber and install them in the
new blade.

CAUTION



Do not bend or discard the stiffeners.
You need to use them again.



If the metal stiffeners are switched,
the blade's wiping efficiency could be
reduced.
So do not use the driver's side metal
stiffeners on the passenger's side, or
vice versa.



Be sure to reinstall the metal
stiffeners in the new blade rubber so
that the curve is the same as it was in
the old blade rubber.

6. Carefully insert the new blade rubber.

Then install the blade assembly in the
reverse order of removal.

(Type B)

1. Raise the wiper arm and turn the blade

assembly to expose the plastic locking
clip.
Compress the clip and slide the
assembly downward; then lift it off the
arm.

Plastic locking clip

Maintenance and Care

Owner Maintenance

6-29

MX-5_8GF7-EA-17J_Edition2

2017-10-31 14:07:27