Command ; Function ; Engine related setting commands - Page 421

2001/10/02 

APPENDIX C HBP MODE COMMANDS - 9

3.2.5 

Engine related setting commands 

Command 

@J+* 

Function 

This command allows the setting of engine related commands.  Each setting depends on the value of the 3 byte 
command string.  

@J+CHR$ (0) +CHR$ (n):

Sets Media Type 

This command allows the printer to change the temperature control for the fuser unit when printing. 

n=0: 

Regular (Default) 

n=1: 

Thick paper 

n=2: 

Thicker paper  

n=3: 

Transparency  

@J+CHR$ (1) +CHR$ (n):

Sets the toner stirring time 

The value of n (0-255) sets the toner stirring time in seconds.  The value 0 gives the default setting of 30 seconds 
stored in the printer, and 1- 6 is fixed at 6 seconds.  Toner is stirred by the  @K+CHR$ (0) command.  It is not 
necessary to set it from the driver. 

@J+CHR$ (2) +CHR$ (n):

Indicates Envelope mode 

n=0 

Normal mode 

n=1 

Envelope mode 

The driver sets the value to 1 if the paper length is from 180 mm to 250 mm, and the value to 0 when it is  shorter 
or longer. 

@J+CHR$ (3) +CHR$ (n):

Sets the envelope mode level 

The value n sets the time limit in continuous envelope printing.  The default (0) is 20 seconds, which represents a 
printing speed of 3 ppm. 

When set to 0, the time limit in continuous envelope printing is set to 20 seconds. 

The printing speed is fastest if the setting is shorter than normal loading speed, such as 1 second or 2 seconds.  
It is not necessary to set it from the driver. 

3.2.6 

Engine related execute commands 

Command 

@K+* 

Function 

This is an immediately executed command. 

@K+CHR$ (0):

Execute toner stirring 

To set the toner stirring time, use the command, @J+CHR$(1)+CHR$(n). 

It is not necessary to set this command from the driver.