Tab Length; Error Message- Page 81

77

CUTTER
ERROR!

• This message appears if the 

tape cutter lever is pressed 
down while a label is being 
printed.

• Turn the P-touch off, then on 

again.

INVAL.
CHRS!

• This message appears if the 

cursor is not below a number 

when you hold down 

and press 

.

• Move the cursor below a 

number before holding down 

 and press 

.

LENGTH
LIMIT!

• This message appears if the text 

is longer than 1 meter when 
you try to print.

• Shorten the text to less than 1 

meter before trying to print.

• This message appears if the 

Length function is used to set 
a label length that is less than 
1.6” (4.0 cm) or more than 
11.8” (30.0 cm).

• Set the label length between 

1.6” (4.0 cm) and 11.8” (30.0 
cm). 

• This message appears if the 

Tab Length function is used to 
set a tab length that is more 
than 11.8” (30.0 cm).

• Set the tab length so that it is 

less than 11.8” (30.0 cm).

LINE
LIMIT!

• This message appears if the 

number of lines in the text is 
greater than the maximum 
number of lines possible for 
the installed tape.

• Reduce the number of lines or 

install a tape of greater width.

MEMORY
FULL!

• This message appears if you 

try to store a text file after 300 
characters have already been 
stored in the memory.

• Delete an unwanted file to 

make room for the new one.

NO
FILES!

• This message appears if you try 

to recall or delete a text file 
from the memory when none 
are stored.

• Store a text file first.

Error Message

Cause

Remedy

Number

Number