4. Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, and P6. ; 5. Unplug all connectores to remove board. However, keep in mind that connectors only ; go in one spot and can not be confused. - Page 2

2 

4.  Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, and P6. 

5.  Unplug all connectores to remove board. However, keep in mind that connectors only 

go in one spot and can not be confused. 

 
6.  Board is held inplace by plastic clip locks. In order to unlock you will need to squeese 

locks and lightly pull-up on board to release.  

(Fig. 1-1) 

Four-clip locks 
hold board down

. 

plastic clip locks

plastic clip locks