

63
5
5
Lower the presser foot lever and then tighten 
the presser foot screw.
Baje la palanca del pie prensatela y, a 
continuación, apriete el tornillo del pie.
1
Presser foot screw /
Tornillo del pie prensatela
Note/
Nota
ā
When sewing with the walking foot, sew at 
medium to low speeds.
ā
Cuando cosa con el pie móvil, utilice una 
velocidad de cosido entre media y baja.
Using the Quilting Foot
Utilización del pie para 
acolchados
The Quilting Foot is useful for darning and
free-motion machine quilting.
El pie para acolchados resulta Ćŗtil para zurcidos y
y acolchados con la mĆ”quina en marcha libre.
1
Turn off the machine.
Desconecte la alimentación de la mÔquina.
2
Raise the needle and the presser foot.
Levante la aguja y el pie prensatela.
3
Loosen the presser foot screw to remove the 
presser foot holder.
Afloje el tornillo del pie prensatela para retirar 
el soporte del pie.
1
Use a coin or screwdriver /
Utilice una moneda o
un destornillador.
2
Presser foot holder /
Soporte del pie prensatela
3
Presser foot screw /
Tornillo del pie prensatela
ā
Use a coin or screwdriver to tighten the 
screw securely. If the screw is loose, the 
needle may hit the presser foot and you 
may be injured.
ā
Before you start sewing, make sure you 
turn the handwheel toward you 
(counterclockwise) to check that the 
needle does not hit the presser foot. 
ā
Be careful not to touch the needle, 
otherwise you may be injured.
ā
Utilice una moneda o un destornillador 
para apretar firmemente el tornillo. Si el 
tornillo estĆ” suelto, la aguja podrĆa 
golpear el pie prensatela y usted podrĆa 
resultar lesionado.
ā
Antes de comenzar a coser, asegĆŗrese de 
girar la rueda hacia usted (hacia la 
izquierda) para comprobar que la aguja 
no golpea el pie prensatela. 
ā
Tenga cuidado de no tocar la aguja pues, 
de lo contrario, podrĆa resultar lesionado.
1
CAUTION/
PRECAUCIĆN
Stitch
Name
Nombre
de la
puntada
Pattern
Dibujo
Length
[mm (inch)]
Longitud
[mm (pulg.)]
Width
[mm (inch)]
Anchura
[mm (pulg.)]
other
Otro
Straight
Stitch
Puntada
recta
Any
Cualquiera
2.5
(3/32)
Darning
Plate
Placa de
zurcir
3
2
1