MEDIA TYPE ERROR; MANUAL FEED; SIZE ERROR XXX- Page 167

6–2

E

E

E

r

r

r

r

r

r

o

o

o

r

r

r

M

M

M

e

e

e

s

s

s

s

s

s

a

a

a

g

g

g

e

e

e

A

A

A

c

c

c

t

t

t

i

i

i

o

o

o

n

n

n

MEDIA TYPE ERROR

Specify the correct media type: XX.

MANUAL FEED

The size of paper in the multi-purpose tray is wrong. Load the correct
size of paper in the multi-purpose tray, or while the printer is in Stop
mode, and then press the 

Go

 switch.

SIZE ERROR XXX

Set the correct paper that you want to use into the indicated tray, or
load the same size paper that you selected in the current driver
setting. 

 “What kind of paper can I use?” in Chapter 1.

NO TRAY ID XXX

Install the specified ID tray.

SIZE ERROR DX

Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting.

 See “What kind of

paper can I use?” in Chapter 1.

SIZE ERROR MX

Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting. 

See “What kind of

paper can I use?” in Chapter 1.

NO DX UNIT

Install the duplex unit correctly. See the duplex unit User’s Guide.

DX LEVER ERROR

Set the duplex lever to the correct position.

NO MX UNIT

Change the job properties or install the Mailbox unit correctly.

DIMM ERROR

Install the DIMM correctly.

Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new card.

CARD ERROR

Make sure of the following points:

•

The cable is connected correctly.

•

The card is installed correctly.

•

The installed card is formatted correctly.

Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new card.

HDD ERROR

Make sure of the following points:

•

The cable is connected correctly.

•

The HDD is installed correctly.

•

The installed HDD is formatted correctly.

Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new HDD.

CARD REMOVAL

Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new CompactFlash
card.

LINE ERROR

Check the Serial interface settings. (baud rate, code type, parity and
hand shake protocols).

BUFFER ERROR

Check the Interface settings.

STORAGE FULL

Delete unnecessary macros or fonts, or use a new card or HDD.