Figure 1-32; Figure 1-31; 1 - 25- Page 33

1 - 25   ABOUT THIS PRINTER

5

Put envelopes in the MP tray so that they touch the back of the tray and remain under the maximum 
paper height guides on both sides of the tray. Put the side to be printed on first, face up, with the 
leading edge (top) of the envelope in first. Do not put more than 3 envelopes in the MP tray at any 
one time, or it may cause a jam.

Figure 1-32

Envelopes that have been creased after they have been printed

At the back of the printer, open the back output tray and push down the two blue tabs one on the 
left and one on the right hand side (as shown in Figure 1-31). When you have finished printing your 
envelopes, close the back output tray to reset the two blue tabs back to their original position.

Figure 1-31

Make sure that the envelopes are neatly stacked and in the proper position in the MP tray. If they 
are not, the envelopes may not be fed properly, resulting in a skewed printout or a jam.