Outside of the machine; Document tray cover; Corner cutter slot- Page 9

ENGLISH

- 7 -

Part names

Outside of the machine

DC connector

Located on the left, backside of the machine.  Aperture for the
AC adapter.

Top cover

For replacing the film cartridge and cutter units.

Viewing window

Located on the top cover.  Allows you to make sure that the
correct type of film cartridge is loaded into the machine.

Document tray

Where documents to be laminated are placed.

Document supporter

Supports the document being laminated.

Document guide

Aligns the left edge of the paper for proper document insertion.

Document tray cover

Easily lifts for the removal small sized documents.

Control panel

Power switch and function button area.

Document output 

Location where the document exits the machine.

Corner cutter slot

Allows you to trim the corners of your document after laminating.
Corners of a document are automatically trimmed after insertion
into the corner cutter slot.

Corner cutter trimmer tray

The corner of your laminated document is placed on this tray to
position it into the corner cutter slot.

Corner cutter dust box

Collects trimmings from the corner cutter.

AC adapter

Plugs into an electrical outlet and the DC connector on the
machine.

Inside of the machine

Film cartridge

Contains the roll film. The label on the cartridge identifies the film
type.
You can use 12.0 inch (A3), 9.0 inch (A4) or 4.8 inch (A6) width
LC cartridges with this machine.

Roller holder lever

Locks/releases the roller holder.

Roller holder

Holds the roller unit.

Side cutter arm

Arm for the side (vertical) cutter unit.

Side cutter units

Blades for side (vertical) cutting.

Top/bottom cutter units

Blades for top/bottom (horizontal) cutting.

Roller

Feeds the document into the unit.