Tab Length; Error Message- Page 119

115

INTERFACE
ERROR!

• This message appears if an 

error occurs while data is 
being sent from the computer 
to the P-touch.

• Cancel the print job, and 

then try printing again.

• This message appears if you 

try to print when the baud 
rates of the computer and the 
P-touch are not the same.

• Cancel the print job, and 

then select the same baud 
rate for both the computer 
and the P-touch.

LENGTH
LIMIT!

• This message appears if the 

text is longer than 3’ 3 1/3” (1 
meter) when you try to print.

• Shorten the text to less than 

3’ 3 1/3” (1 meter) before try-
ing to print.

• This message appears if the 

Length function is used to set 
a label length that is less than 
1.6 inches (4.0 cm) or more 
than 11.8 inches (30.0 cm).

• Set the label length between 

1.6 inches (4.0 cm) and 11.8 
inches (30.0 cm). 

• This message appears if the 

Tab Length function is used 
to set a tab length that is 
more than 11.8 inches (30.0 
cm).

• Set the tab length so that it is 

less than 11.8 inches (30.0 
cm).

LINE
LIMIT!

• This message appears if the 

number of lines in the text is 
greater than the maximum 
number of lines possible for 
the installed tape.

• Reduce the number of lines 

or install a tape of greater 
width.

MEMORY
FULL!

• This message appears if you 

try to store a text file after 
2500 characters have already 
been stored in the memory.

• Delete an unwanted file to 

make room for the new one.

NO
FILES!

• This message appears if you 

try to recall or delete a text 
file from the memory when 
none are stored.

• Store a text file first.

Error Message

Cause

Solution