Remote Vehicle Start ; Rear View Camera (if equipped); See Section 2 of your Owner Manual.- Page 21

The rear park assist display is located in

the headliner near the rear window and

provides the following indicators when

an object is detected:

• At 8 ft. (2.5 m), one light illuminates.

• At 40 in. (1.0 m), two lights illuminate.

• At 23 in. (0.6 m), all three lights

illuminate.

• At 12 in. (0.3 m), a chime sounds and

all three lights flash.

Use the Driver Information Center to

turn off the system when towing. The

system automatically turns back on after

each vehicle start.

Rear View Camera (if equipped)

The rear view camera displays a view

of the area behind the vehicle on the

navigation system screen when the

vehicle is shifted into Reverse. The rear

park assist indicators will appear on the

screen, indicating the distance and posi-

tion of an object behind the vehicle.

See Section 2 of your Owner Manual.

21

Remote Vehicle Start 

(if equipped)

This feature allows you to start the

engine from outside the vehicle by

using the Remote Keyless Entry (RKE)

transmitter. The remote start capability

must be turned on using the Driver

Information Center.

Based on outside temperature, the

vehicle’s automatic climate control

system will default to a heating or

cooling mode and the heated seats

(if equipped) will turn on.

Starting the Vehicle

To remote start the vehicle:

1. Aim the RKE transmitter at the

vehicle. (Transmitter range is within

approximately 195 feet of the

vehicle.)

2. Press and release the  (Lock)

button on the transmitter.

3. Immediately press and hold the 

(Remote Start) button for about four

seconds. When the vehicle starts,

the parking lamps will light and

remain on while the engine is

running. The engine will continue

running for 10 minutes.

4. Repeat these steps for a 10-minute

time extension. Only two consecutive

remote starts are allowed.

When you enter the vehicle after a

remote start, the ignition must be turned

to the On position before driving.

Canceling a Remote Start

If you wish to turn off the engine instead

of driving after a remote start, perform

one of the following functions:

• Press and hold the  (Remote Start)

button until the parking lamps turn off.

• Press and release the Hazard

Warning Flashers button. Press it

again to turn off the flashers.

• Turn the key in the ignition switch to

the On position and then off.

See Section 2 of your Owner Manual. 

Note:

The Remote Vehicle Start feature

will not operate if the key is in the igni-

tion, the hood or liftgate is open, or the

Check Engine light is illuminated on the

instrument panel cluster.

Enclave 2008 A   1/30/07  3:39 PM  Page 21