Remote Keyless Entry; Warnings and Messages; See Section 3 of your Owner Manual. - Page 5

5

(Trip/Fuel):

Press this button to

display the following trip and fuel

information:

• Odometer

• Trip Odometers

• Fuel Range

• Average Economy

• Timer

• Fuel Used

• Average Speed

Warnings and Messages

The DIC provides a variety of vehicle

warning messages (depending on

optional equipment) if a problem is

sensed in a vehicle system. To

acknowledge a message and clear it

from the display, press the DIC reset

stem or any DIC button. Some urgent

messages cannot be cleared from the

DIC display. 

If you have a current OnStar subscrip-

tion, and a warning message appears,

you can press the blue OnStar button

and speak to an OnStar Advisor. In

many vehicles, OnStar Advisors can

access certain diagnostic information

and can tell you how serious the prob-

lem is and what you should do about it.

See Section 3 of your Owner Manual. 

Note:

Your vehicle’s warnings and

messages provide critical information

that can prevent damage to your vehi-

cle. Review your Owner Manual to

become familiar with the information

displayed and the action required.

Remote Keyless Entry

The Remote Keyless Entry (RKE) trans-

mitter allows you to lock and unlock your

vehicle and perform other functions

while up to approximately 195 feet away

from the vehicle. 

RKE functions include:

(Remote Vehicle Start)

(if equipped):

This feature can be used to start the

engine from outside the vehicle. (See

Remote Vehicle Start.)

(Lock):

Press this button to lock all

the doors. RKE feedback (light flash

and/or horn chirp) can be programmed

using the Driver Information Center

(DIC).

(Unlock):

Press this button to unlock

the driver’s door. Press it again within

five seconds to unlock all remaining

doors. RKE feedback (light flash) can be

programmed using the DIC.

(Power Liftgate)

(if equipped):

Press and hold this button until the lift-

gate starts moving to open and close

the liftgate. The taillamps will flash and a

chime will sound when the liftgate is

moving.

(Vehicle Locator/Panic Alarm):

Press and release this button to locate

your vehicle. The turn signal lamps will

flash and the horn will sound three

times.

Press and hold the button to activate the

panic alarm. The turn signal lamps will

flash and the horn will sound for 30

seconds. Press the button again or turn

the ignition to On to cancel the alarm.

See Section 2 of your Owner Manual.

SAFETY & SECURITY

Enclave 2008 A   1/30/07  3:38 PM  Page 5