Trailer Towing; Tire Pressure Monitor; See Section 4 of your Owner Manual.- Page 23

23

Trailer Towing

The Tow/Haul mode

(if equipped) assists

when pulling a heavy

trailer by reducing the

frequency of trans-

mission shifts and

improves the control of vehicle speed.

To turn on this feature, press the 

(Tow/Haul) button located on the center

console in front of the shift lever. Press it

again to turn off the feature.

See Section 4 of your Owner Manual.

Tire Pressure Monitor

The Tire Pressure Monitor alerts you

when a significant reduction in pressure

occurs in one or more of your vehicle’s

tires by illuminating the  (Low Tire

Pressure) warning light on the instru-

ment panel. The low tire pressure warn-

ing light will remain on until you correct

the tire pressure.

A CHECK TIRE PRESSURE message

may appear on the DIC.

Correcting the Tire Pressure

When the low tire pressure warning light

illuminates, you must fill the tire to the

proper tire inflation pressure. The Tire

and Loading Information label, located

on the center pillar below the driver’s

door latch, shows the correct inflation

pressure for the tires when they’re cold.

“Cold” means your vehicle has been

sitting for at least three hours or driven

no more than one mile. 

You can temporarily remove the DIC

message by acknowledging it with your

DIC controls. However, at the next

vehicle startup, the DIC message will

reappear if the tire pressure has not

been corrected.

You may notice during cooler conditions

that the low tire pressure warning light

will appear when the vehicle is first

started and then turn off as you start to

drive the vehicle. This could be an early

indicator that your tire pressures are

getting low and need to be inflated to

the proper pressure.

See Section 5 of your Owner Manual.

Note:

The Tire Pressure Monitor can

alert you about low tire pressure, but it

doesn’t replace normal monthly tire

maintenance.

Resetting the Oil Life System

The Oil Life System calculates engine

oil life based on vehicle use and dis-

plays CHANGE OIL SOON in the Driver

Information Center (DIC) when it’s

necessary to change your engine oil

and filter. The Oil Life System should be

reset to 100% only following an oil

change.

To reset the Oil Life System:

1. Turn on the ignition, with the engine

off.

2. Press the 

(Vehicle Information)

button until the DIC displays OIL LIFE

REMAINING.

3. Press and hold the  (Set/Reset)

button until 100% is displayed.

4. Turn off the ignition.

See Section 5 of your Owner Manual.

Enclave 2008 A   1/30/07  3:39 PM  Page 23