Front Parking and Turn Signal Lamps; Passenger’s Side Headlamp Shown- Page 293

6-39

Passenger’s Side Headlamp Shown

A. Horizontal Aim Adjustment Screw

B. Horizontal Block Index Plate

C. Vertical Aiming Level

Start with the horizontal aim. The adjustment screws can
be turned with an E8 Torx

R

 socket.

Once the horizontal aim is adjusted, then adjust the
vertical aim.

1. Turn the horizontal aiming screw until the indicator

is lined up with zero.

2. Turn the vertical aiming screw until the level bubble

is lined up with zero.

Front Parking and Turn Signal Lamps

1. Remove the headlamp assembly. Refer to the

removal procedure earlier in this section.

2. Remove the rubber bulb access cover.

3. Twist the sidemarker lamp socket, located on 

the outboard side of the headlamp assembly,
counterclockwise and pull it from the 
headlamp assembly.

4. Holding the base of the socket, pull the old bulb

from the socket.

5. Push the new bulb into the socket.

6. Reverse Steps 1 through 3 to reinstall the 

lamp assembly.