CONNECTING THE P-TOUCH TO A COMPUTER; To connect the P-touch to the computer:- Page 10

6

This machine is equipped with a USB port, allowing you to connect the P-touch to your IBM
PC-compatible or Macintosh computer, and print labels and stamps created using the P-touch
Editor software.

☞

The P-touch Editor software and the printer driver must be installed before the P-touch is
connected to the computer or turned on. Follow the installation procedure on pages 7
through 16 to install the P-touch Editor software and the printer driver, and connect the
P-touch to the computer when you are instructed to do so.
A USB interface cable is not included with the PT-2300. When connecting the P-touch
to a computer, use a standard USB cable (high-speed compatible with series A and B
connectors).

To connect the P-touch to the computer:

1

Insert the flat (A) connector on the USB cable into the USB port on the computer.

2

Insert the square (B) connector on the USB cable into the USB port on the right side of the
P-touch.

3

Turn on the P-touch.

☞

The USB cable needed for connecting the P-touch to the computer is not included. Be
sure to use a cable that meets the following specifications.

CONNECTING THE P-TOUCH TO A COMPUTER

A

A

C

C

C

C

B

B

Overmolded 
Series “A” Plug

Overmolded 
Series “B” Plug

Detail A-A
(Series 
  “A” Plug)

Detail B-B
(Series 
  “B” Plug)

15.7

7.5

10.5

11.5

12.0

12.0

27.0

32.0

9.0

9.0

Optional Molded

Strain Relief