BE-0901E-AC-PC• BE-1201B-AC-PC- Page 45

BE-0901E-AC-PC• BE-1201B-AC-PC

2-17

Chapter 2 Preparation of Embroidery Machine

!

!

!

!

 When the machine is turned on:

"E-07" may appear on the operation panel while a buzzer sounds intermittently. In such a case, the

machine is not ready to start because the needle bar case is not positioned correctly, and thus the

needles are not in proper alignment with the holes of the needle plates. Follow the steps below to fix

this.

W1585

!

!

!

!

 BE-0901E-AC-PC

W1586

!

!

!

!

 BE-1201B-AC-PC

W1587

1. Check if the needles stop in the normal

position.

When cam plate [2] is raised, it is in the
automatic jump position. This is the normal
position.

2. Turn knob [3] slowly.

If knob [3] cannot be turned or is too heavy to
rotate, thread take-up [1] or the needle bar is
not in the normal position. Check if any
obstacle interferes with the needle end or the
presser foot.

Note) Do not turn the knob forcibly.

3.  There is a dead zone in which the needle

bar case cannot be moved even by turning
knob [3]. Turn the knob to the normal
position in the vicinity of the center of the
dead zone.

4. Press STOP 

 .

5.  A buzzer sounds and the X and Y carriages

move automatically so as to bringthe hoop
center to the home position or to the position
where it was located at the end of the
previous operation.

 [2]

 [3]

 [3]