Troubleshooting; Overview; Installation Problems- Page 112

11 - 1 TROUBLESHOOTING

11

11

Troubleshooting

Overview

This chapter describes procedures for troubleshooting problems you 
may encounter with a Brother print server, it is divided into the 
following sections: 

1

Installation Problems

2

Intermittent Problems 

3

Protocol-Specific Troubleshooting

Installation Problems

If you cannot print over the network, check the following:

1

Make sure that the printer is powered on, is on-line and ready to 
print.

Verify that the printer and the configuration are good by printing 
the printer settings page. Refer to the Quick Setup Guide. If the 
test fails, check:

a

If the LED is not blinking after connected to the network, then 
the network firmware settings may be corrupted. 

b

In this event, try to restore the factory default settings of the 
print server. To reset the print server, turn off the printer and 
then turn it on while holding down the + button. Keep the 
button pressed down until the LCD display shows 

READY

. You 

can check the settings by printing the printer settings page.