Figure 1-39; 1 - 32- Page 39

ABOUT THIS PRINTER   1 - 32

6

Press and slide the paper-width guide to fit the envelope size.

Figure 1-39

7

Send the print data to the printer.

8

After you finish the print job, close the face-up output tray.

DL size double-flap envelopes

■

If the DL size double flap envelope is creased after printing, go to the Basic tab, select Paper 
Size and then select DL Long Edge. Put a new DL size double-flap envelope in the MP tray with 
the longest edge of the envelope in first, then print again.

When you put envelopes in the MP tray, please remember the following;

■

During printing, the inside tray rises to feed envelopes into the printer.

■

The side to be printed on must be face up.

■

Put the right side edge of the envelope in first and push it gently into the tray.

■

The top of the envelope stack must be under the maximum paper height guides that are on both 
sides of the tray. 

■

If envelopes get smudged during printing, in the printer driver select MP Tray as the Paper 
Source for a straight paper path. Then, set the Media Type to Thick Paper or Thicker Paper 
to increase the fixing temperature. To adjust the print density setting, see Density adjustment on 
page 2-8.

■

Envelope joints that are sealed by the manufacturer should be secure.

■

All sides should be properly folded without any wrinkles or creases.