Macintosh®; For USB Interface Users (For Mac OS® X 10.2.4 or greater); Improper Setup- Page 28

Installing the Driver & Software

26

STEP 2

Macintosh

®

M

aci

n

to

sh

®

US

B

3

For USB Interface Users
(For Mac OS

®

 X 10.2.4 or greater)

Important

Make sure that you have finished the 
instructions from STEP 1 

Setting Up the 

Machine

 on pages 4 through 14.

Note

• For  Mac  OS

®

 X 10.2.0 to 10.2.3 users, upgrade to 

Mac OS

®

 X 10.2.4 or greater. (For the latest 

information for Mac OS

®

 X, visit 

http://solutions.brother.com)

• Make sure there are no memory cards or a USB 

Flash memory drive inserted into the media drives 
or USB direct interface at the front of the machine.

1

Using both hands, use the plastic tabs on both 
sides of the machine to lift the scanner cover 
until it locks securely into the open position.

2

Insert the USB cable into the USB socket 
marked with a 

 symbol. You will find the 

USB socket inside the machine on the right as 
shown below.

3

Carefully route the USB cable through the 
trench and out the back of the machine as 
shown below and connect the cable to your 
Macintosh

®

.

Improper Setup

• DO NOT connect the machine to a USB port on 

a keyboard or a non-powered USB hub. 
Brother recommends that you connect the 
machine directly to your Macintosh

®

.

• Make sure that the cable does not restrict the 

cover from closing, or an error may occur.

• Make sure you use a USB 2.0 cable that is no 

longer than 6 feet (2 meters) long.

4

Lift the scanner cover to release the lock  .
Gently push the scanner cover support 
down   and close the scanner cover  .