CHANGING THE PATTERN SIZE WHILE MAINTAINING THE DESIRED THREAD DENSITY (STITCH RECALCULATOR); Press .; Press - Page 7

6

CHANGING THE PATTERN SIZE WHILE MAINTAINING 

THE DESIRED THREAD DENSITY (STITCH RECALCULATOR)

In the embroidery edit screen, the size of the pattern 
can be changed while the desired thread density is 
maintained.
With this function, the pattern will be enlarged or 
reduced at a larger ratio than with normal pattern 
resizing.

a

Select the pattern to be resized, and then 

press .

b

Press .

c

Press 

 to enter Stitch Recalculator mode 

(

).

d

When the following message appears, press 

.

→

The pattern will be returned to its original size, 
angle, and position as it was before it was edited.

Note

• Be sure to sew trial embroidery using same fabric 

and threads as project in order to check the 
embroidering results.

Note

• This function cannot be used with alphabet 

character patterns, frame patterns or border 
patterns. However, a border pattern can be edited 
after this function has been used.

• Patterns with a large number of stitches (about 

100,001 or more) cannot be resized while 
maintaining a desired thread density. The maximum 
limit for the number of stitches differs depending on 
the data size of pattern.

• If this function is used, thread density is maintained 

while the pattern is enlarged/reduced. However, the 
needle drop point pattern is not entirely maintained. 

Use the normal resizing mode 

 depending on 

the results of trial embroidering. 

Memo

• Stitch Recalculator cannot be used if 

 does 

not appear.