Dome Lamp (If Equipped)- Page 283

yellow

blue     

6-43

Back-Up Lamp

The back

-

up lamps are located in the trunk lid applique.

(Refer to the trunk lid applique removal procedure earlier
in this section for graphic and further instructions.)

1. Remove the trunk lid applique.

2. Twist and pull the back

-

up lamp socket from the

trunk lid applique.

3. Twist and pull the bulb from the back

-

up 

lamp socket.

To install the new bulb:

1. Twist and push the bulb into the back

-

up 

lamp socket.

2. Twist and push the back

-

up lamp socket into the

trunk lid applique.

3. Reinstall the trunk lid applique.

Dome Lamp (If Equipped)

1. Grasp the front center and rear center positions of the

dome lamp housing and squeeze together until the
housing releases from the base plate. A screwdriver
may be necessary to pry the assembly loose.

2. Lift the plastic locking tab on the electrical

connector and pull the connector from the dome
lamp assembly.

3. Grasp the bulb housing located in the center of the

assembly and pull straight up.

4. Pull the bulb out of the socket.

5. Push in a new bulb.

6. Replace the socket into the dome lamp assembly.

7. Reconnect the dome lamp assembly to the wiring

harness, making sure the connector tab snaps 
into place.

8. Reposition the dome lamp assembly to the roof, and

gently push the assembly into the base plate.