Fig. 4-53; Fig. 4-54; Low-Voltage Power Supply PCB ASSY- Page 102

CHAPTER 4  DISASSEMBLY AND RE-ASSEMBLY

4-30

  3.14

Low-Voltage Power Supply PCB ASSY

(1)  Remove the M3x8 Taptite screw to remove the insulation sheet.

(2)  Slightly lift up the low-voltage power supply PCB ASSY from the frame and disconnect the

engine PCB connector.  Then lift the power supply PCB ASSY further and disconnect the
halogen heater lamp connector.

(3)  Remove the M3.5x6 screw to disconnect the ground wire from the base plate.

Fig. 4-53

(4)  Remove the M3x6 Taptite screw securing the AC inlet holder.

(5)  Turn the AC inlet to the right to release it and remove the AC inlet ASSY and the low-

voltage power supply PCB together.

Fig. 4-54

NOTE:

When re-assembling the AC inlet holder, fix the holder onto the positioning bosses first, then
secure it to the frame with the screw.  (Refer to the figure above.)

Taptite, bind M3x8

AC inlet holder

Low-voltage power

supply PCB ASSY

Ground wire

Screw M3.5x6

Halogen heater
lamp connector

Engine PCB connector

Low-voltage power
supply PCB ASSY

Base plate

Taptite, cup M3x6

AC inlet holder

Main frame

(positioning boss)

Insulation sheet

Step (2)