Reloading using the FTP Protocol from a command prompt; Reloading using the FTP Protocol from a - Page 164

APPENDIX A - 6

5

Netware GET from a server

You must have a Netware server on your network (running IPX/
SPX) and you must store the new firmware file in the SYS/Login 
directory of the server. In this case, your PC makes the Print/Fax 
server read the firmware data from the assigned Netware 
server, the Print/Fax server attaches to the Netware server and 
reads the firmware itself.

Reloading using the FTP Protocol from a 
command prompt

By specifying the Print/Fax server PASSWORD AS THE 
USERNAME when logging on, it becomes possible to upgrade the 
firmware of the Print/Fax server or printer (if supported). The 
following example assumes that the Print/Fax server password is 

cambridge

D:\>ftp

ftp> open 220.0.250.200

Connected to 220.0.250.200.

220 FTP print service:V-1.05/Use the network 

password for the ID if updating.

User (220.0.250.200:(none)): cambridge

230 User cambridge logged in.

ftp> bin

200 Ready command OK.

ftp> hash

Hash mark printing on  ftp: (2048 bytes/hash mark) .

ftp> send brnt261.blf

200 Ready command OK.

150 Transfer Start

#################################################

########

#################################################

#################################################

#################################################

###########################

226 Data Transfer OK/Entering FirmWareUpdate mode.

ftp: 1498053 bytes sent in 8.52Seconds 

175.77Kbytes/sec.

ftp> close

226 Data Transfer OK.

After sending firmware to the machine, do not turn off the 
machine until after the machine has performed an automatic 
restart.