BE-0901E-AC-PC• BE-1201B-AC-PC- Page 243

BE-0901E-AC-PC• BE-1201B-AC-PC

13-3

Chapter 13 Connection and Installation of Optional Equipment

!

Winding lower thread

W1638

1. Turn on the power switch.

2. Fit bobbin [1] to the bobbin winder shaft [2].

3. Pass a thread through thread guide [3].

4. Wind the thread around bobbin [1] several times in the direction of the arrow.

5. Press bobbin hold [4].

Note) • If the thread cannot be wound evenly, loosen screw [5] and move thread guide [3] from side to side

for adjustment.

• To wind more thread around the bobbin, loosen screw [5] and shift bobbin hold [4].

6. After winding is finished, remove the bobbin from the bobbin winder shaft and trim the thread using

tread trimmer [7].

Note) • If the thread passed though thread guide [3] comes off, loosen knob [8]. If the thread is wound

loosely, tighten knob [8].

• If circuit protector [9] is activated, the bobbin winder motor does not rotate. Wait for a while until the

motor cools and press the circuit protector. (If the motor is still hot, the pressed circuit protector will
come out.)

[3]

[5]

[8]

[7]

[2]

[1]

[9]

[4]

[6]