Improper Setup; Installing the Driver & Software; a keyboard or a non-powered USB hub. - Page 22

Installing the Driver & Software

20

STEP 2

W

in

dow

s

®

US

B

Windows

®

12

Carefully route the USB cable through the 
trench and out the back of the machine as 
shown below and connect the cable to your 
computer.

Improper Setup

• DO NOT connect the machine to a USB port on 

a keyboard or a non-powered USB hub. 
Brother recommends that you connect the 
machine directly to your computer.

• Make sure that the cable does not restrict the 

cover from closing, or an error may occur.

• Make sure you use a USB 2.0 cable that is no 

longer than 6 feet (2 meters) long.

13

Lift the scanner cover to release the lock  .
Gently push the scanner cover support 
down   and close the scanner cover  .

14

Turn on the machine by connecting the power 
cord.

The installation of the Brother drivers will 
automatically start. The installation screens 
appear one after another. 

Please wait, it will 

take a few seconds for all the screens to 
appear.

Improper Setup

DO NOT try to cancel any of the screens during 
this installation.

15

When the On-Line Registration screen is 
displayed, make your selection and follow the 
on-screen instructions.

16

Click 

Finish

 to restart your computer.

After restarting the computer, you must be 
logged on with Administrator rights. 

Note

After restarting the computer, the Installation 
Diagnostics will run automatically. If the 
installation is unsuccessful, the installation results 
window will be shown. If the Diagnostics shows a 
failure, please follow the on-screen instructions or 
read the on-line help and FAQ’s in 

Start/All Programs/Brother/MFC-XXXX

.