Step 2; Current Setting; Changing your Computer’s - Page 5

4

English

5

Put the NC-7100w print server 
connector firmly into the connector of 
the main controller board by aligning 
the two screws to the groove of the 
printer, and then secure it with the two 
screws.

6

Close the interface access cover.

7

Put the side cover back on.

8

Plug the printer back in and then turn on 
the power switch.

9

Make sure that the POWER LED of the 
print server is on.

10

Print a Network Configuration Page and 
make sure that the IP address has been 
set to 169.254.x.x (where x.x are 
numbers between 1 and 254). If the IP 
address has not yet initialized, wait for 
up to 5 minutes and then print another 
Network Configuration Page.

Changing your Computer’s 
Wireless Settings to configure 
the NC-7100w

Before you can use the printer in a wireless 
network, the NC-7100w wireless print server 
must be configured to match your network 
configuration.

To configure the NC-7100w from a wireless 
computer on your network, you must 
temporarily change your current wireless 
settings. Before changing the current 
wireless settings of your PC, we recommend 
you make a note of your current wireless 
network settings using the chart on the right. 
You will need to return to these settings at the 
end of Step 3.

Current wireless network settings of 
your computer

See Other Information in this Quick 
Setup Guide for information how to 
print the Network Configuration 
Page.

POWER LED

We recommend you to contact your 
network administrator if you need 
assistance with your computers 
wireless settings.

Item

Current Setting

Communication Mode: 
(Infrastructure / Ad-hoc)

Network Name (SSID)

Channel: (1-14)

Encryption: 
(NONE / WEP / Other)

Encryption Key Size 
and Type:
(64 bit, 128 bit / ASCII, 
HEX / Other)

Encryption Key:

Step 2