Rear Storage Area; Do not open the sunroof if the crossrails; are not in the full rear position. This could cause- Page 125

2003 Buick Rendezvous Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

background image

To adjust the crossrail(s), the sunroof stop (A) must be
removed.

To remove the sunroof stop, do the following:

1. Find the tool (B) located in a bag in the glovebox

labeled “tool kit-acsry”.

2. Use the tool to remove the screw located in the

side rail assembly in front of the front crossrail.

3. Repeat for the other side.

4. Put the tool and the screws back in the plastic bag

in the glove box.

To adjust the crossrails, lift the release levers on each
side to unlock them. Slide the crossrails forward or
backward, as needed, to accommodate loads of various
sizes.

After repositioning the crossrails, push the release lever
down. This will lock the crossrails in place.

Notice: Do not open the sunroof if the crossrails
are not in the full rear position. This could cause
damage to the sunroof glass panel and/or the
crossrails.

When you are done using the crossrails you must
replace the sunroof stop.

To replace the sunroof stop, do the following:

1. Put the crossrails in the full rear position.

2. Using the tool, put the screws back into each side

rail assembly. Make sure the screws are in the first
hole in front of the crossrail.

Rear Storage Area

There are four small storage compartments in the rear
of your vehicle. One is on the passenger’s side, two
are on the driver’s side and one is on the floor by the
tailgate. To remove the covers, lift up on the tabs. If your
vehicle has the 10-speaker system, the compartment
on the passenger’s side and the long compartment
on the driver’s side will be equipped with speakers.

2-41

2003 - Rendezvous OM

Detailed Information for 2003 Buick Rendezvous Owner Manual

Lists of information found in 2003 Buick Rendezvous Owner Manual - Page 125

  • 1. Find the tool (B) located in a bag in the glovebox labeled “tool kit-acsry”.
  • 2. Use the tool to remove the screw located in the side rail assembly in front of the front crossrail.
  • 3. Repeat for the other side.
  • 4. Put the tool and the screws back in the plastic bag in the glove box.
  • 1. Put the crossrails in the full rear position.
  • 2. Using the tool, put the screws back into each side rail assembly.

Related Documents for 2003 Buick Rendezvous Owner Manual