Erasing Channels- Page 125

yellow

blue     

2-63

3. Return to the Universal Transmitter in your vehicle and

firmly press and release the Universal Transmitter
button you have already programmed for two to three
seconds. Press and release the button again (you may
need to do this step up to three times) to make sure
that the Universal Transmitter has been trained to the
garage door opener motor head unit. Check that the
training was successful.

The garage door opener should now recognize the
Universal Transmitter. You may either use the Universal
Transmitter or the hand

-

held transmitter to open the

garage door.

If after following these instructions, you still have
problems training the garage door opener, contact the
Universal Transmitter manufacturer at 1

-

800

-

355

-

3515.

Erasing Channels

To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (after 20 seconds). Release both buttons.

Accessories

Accessories for the Universal Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1

-

800

-

355

-

3515.