When replacing the battery, use care not to touch; any of the circuitry. Static from your body; transferred to these surfaces may damage - Page 74

yellow

blue     

2-12

NOTICE:

When replacing the battery, use care not to touch
any of the circuitry. Static from your body
transferred to these surfaces may damage 
the transmitter.

For battery replacement, use a Duracell

R

 battery, type

DL

-

2032, or a similar type.

To replace the battery:

1. Insert a coin into the notch near the key ring. 

Turn the coin to the left to separate the two halves of
the transmitter.

2. Once the transmitter is separated, use a pencil eraser

to remove the old battery. Do not use a metal object.

3. Remove and replace the battery. Insert the new

battery as the instructions under the cover indicate.

4. Snap the transmitter back together tightly to be sure

no moisture can enter.

5. Test the operation of the transmitter with your

vehicle. If the transmitter does not work,
resynchronize the transmitter.

Resynchronization

After you have changed the battery in your transmitter,
or if only the instant alarm button works, the transmitter
needs to be resynchronized to the receiver. Do this by
pressing and holding both the LOCK and UNLOCK
buttons on the transmitter for about eight seconds. You
must be within range of the vehicle.

Once the transmitter has been resynchronized, the horn
will chirp and the exterior lamps will flash once. The
system should now operate properly.