Changing the Set Vehicle Speed; Canceling the system; Turning off the system- Page 272

Changing the Set Vehicle Speed

(To accelerate/decelerate using the
RES switch)

When the RES switch is pressed up
(SET+), the vehicle accelerates and
when the RES switch is pressed down
(SET-), it decelerates.



Press and release immediately: 1
km/h (1 mph)



Press and hold: 10 km/h (5 mph)

(To increase speed using accelerator
pedal)

Depress the accelerator pedal and
press the RES switch up (SET+) or
down (SET-) at the desired speed. If
the switch is not operated, the system
returns to the set speed after you
release your foot from the accelerator
pedal.

NOTE



The warnings and brake control do
not operate while the accelerator
pedal is depressed.

Canceling the system

When the following operations are
performed, the MRCC system is
canceled, and the MRCC set indication
(green) switches to the MRCC standby
indication (white) at the same time.



The CANCEL switch is pressed.



The brake pedal is depressed.



The shift lever is in the reverse (R)
position.

 
Under the following conditions, the
MRCC cancel indication is displayed in
the multi-information display and a
single beep sound is heard.



The DSC has operated.



The Smart Brake Support (SBS) has
operated.



When traveling on a downslope for a
long period of time.



There is a problem with the system.



The vehicle speed decreases to less
than 25 km (16 mph).



The shift lever is shifted to neutral
(N) for a certain period of time.



The clutch is depressed for a certain
period of time.



The engine stalls.



The front radar sensor cannot detect
target objects (during rain, fog, snow
or other inclement weather
conditions, or when the radiator
grille is dirty).



The parking brake is applied.



Any of the doors is opened.



The driver's seat belt is unfastened.



The operation frequency of the
braking by the MRCC control is high.

Resuming control

If the MRCC system is canceled, you
can resume control at the previously
set speed by pressing the RES switch
and after all of the operation
conditions have been met.

NOTE

If the set speed is not indicated in the
display, the control does not resume
even if the RES switch is pressed.

Turning off the system

When the MRCC switch is pressed
while the MRCC is operating, the
MRCC turns off.

▼

Shift-up/Shift-down Request
Display

The shift-up or shift-down request
display might be displayed while the
MRCC is operating. When this occurs,
shift gears because the gear position is
not appropriate.

When Driving

i-ACTIVSENSE

4-126

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09